Kitchen sinks

Kitchen Sink Size Guide: How to Choose the Right Size

5 min read

Stainless steel kitchen sink on a grey counter with a measuring tape, steel kadai and pot

The right kitchen sink size depends on three things: the width of the cabinet under it, the depth of your counter, and the size of the utensils you wash every day. Get these right and the sink fits cleanly, drains well and doesn't splash. This guide walks through each step and lists the sizes Fossa makes, so you can shortlist in a few minutes.

Step 1: Measure the cabinet, not just the counter

The sink bowl hangs inside the base cabinet, so the inside width of that cabinet sets your maximum sink width.

  • Measure the inside width of the base cabinet, wall to wall, in inches.
  • Subtract the frame and panels. The sink's outer edge must sit on the counter and the bowl must clear the cabinet sides. Your carpenter or fabricator can confirm the exact cut-out.
  • Check pipes and the waste outlet. Note where the drain point and water lines are, so the bowl's outlet lines up with them.

Step 2: Check your counter depth

Most Indian kitchen counters are around 24 inches (about 600 mm) deep. A sink that is 18 to 20 inches front to back leaves room on the counter in front of and behind it. If your counter is shallower, choose an 18-inch-deep sink or ask your fabricator before ordering a 20-inch model.

Step 3: Match the size to how you cook

Think about the largest item you wash most days: a kadai, a pressure cooker, a large tawa or a big pateela. The table below is a practical starting point.

Your kitchen Sizes to look at (inches) Why
Bar counter, utility area or a very small kitchen 18 × 16, 20 × 17 Fits narrow cabinets; fine for glasses, small vessels and hand washing.
Small family, compact modular kitchen 21 × 18, 22 × 18, 24 × 18 The most common sizes; enough room for daily utensils without taking much counter space.
Family that cooks a lot, large vessels 27 × 20, 30 × 18, 32 × 20 A wider single bowl lets a kadai or pressure cooker lie flat while you scrub it.
Washing and rinsing at the same time 32 × 18, 37 × 18, 45 × 20 double bowl One bowl for soaking or washing, the other for rinsing or draining.
Need a drying area next to the sink 32 × 18 to 45 × 20 with drain board The drain board gives a sloped place to drain washed vessels.
L-shaped kitchen with a free corner 36 × 36 corner sink Uses the corner, which is otherwise hard to use.

Step 4: Choose the bowl depth

Fossa sinks are 8, 9 or 10 inches deep.

  • 10 inches holds big vessels and keeps splashes inside the bowl. Good for heavy daily cooking.
  • 9 inches is a balanced choice for most homes.
  • 8 inches is easier to reach into for shorter users and suits lighter use.

Step 5: Single bowl, double bowl or drain board?

  • Single bowl: one large, open space. Best when you wash big utensils and have limited width.
  • Double bowl: two separate bowls for washing and rinsing, or for keeping vegetables apart from dishes. Needs a wider cabinet.
  • Drain board: a single or double bowl with a built-in drying area. Useful if you don't have a separate dish rack.
  • Tap hole: some sinks have a hole for a deck-mounted tap. If your tap comes out of the wall, you don't need one.

Fossa kitchen sink sizes at a glance

Type Sizes available (inches, L × W × D)
Handmade single bowl 18 × 16 × 9, 20 × 17 × 9, 21 × 18 × 9, 22 × 18 × 9, 24 × 18 × 10, 24 × 24 × 10, 27 × 20 × 10, 30 × 18 × 10, 32 × 20 × 10
Handmade double bowl 32 × 18 × 10, 32 × 20 × 10, 37 × 18 × 10, 45 × 20 × 10
Single bowl with drain board 32 × 18, 32 × 20, 37 × 18, 40 × 18, 45 × 20
Corner double bowl with drain board 36 × 36 × 10
Machine-made (hydraulic) 18 × 16, 20 × 17, 21 × 18, 22 × 18, 24 × 18 single bowl; 37 × 18 and 45 × 20 double bowl; 37 × 18 and 45 × 20 with drain board
Quartz 18 × 16, 18 × 18 round, 24 × 18, 30 × 19, 31 × 19 single bowl; 37 × 18 double bowl; 36 × 18 with drain board
Smart waterfall and piano 24 × 18, 27 × 18, 30 × 18, 37 × 18, 40 × 18, 47 × 18

Exact sizes, colours and stock are listed on each product page. Browse the full Fossa kitchen sink range, or go straight to single bowl, double bowl or drain board sinks.

Quick checklist before you order

  • Inside width of the base cabinet, measured.
  • Counter depth checked, and the cut-out confirmed with your fabricator.
  • Drain point position noted.
  • Bowl type chosen: single, double or with drain board.
  • Depth chosen: 8, 9 or 10 inches.
  • Tap type decided: wall-mounted or deck-mounted (tap hole).

Not sure which size fits? Send us your cabinet width and counter depth on WhatsApp and our team will suggest options.

Share WhatsApp Facebook

Shop Kitchen sinks

View all

Need help choosing?

Talk to our product team about sizes, models, pricing and availability.

Already bought from Fossa? Register your warranty